Thanks for stopping by. For a peek at my studio click here.

Tuesday, May 30, 2017

Angelina Film – The Baking Experiment

I’ve been working on a mermaid for a contest being hosted by Jack Johnston and I’m very pleased with how she is coming out. As I was getting ready to add her tail fin I did a lot of research. I looked at videos, I did a google search, I looked at YouTube and most of what I found recommended to add the fin then bake the clay used to attach it to the body with a heat gun. Yikes! That sounded a little scary to me.  Heat guns get hot, much hotter than the temperature necessary to cure clay so I thought I would do an experiment with baking the Angelina Film, on the doll, in the oven.


This is the faux tail I made for my 1st experiment. I used “The Ultimate” glue to attach the wires to the bottom layer of film. When adding the glue to the wires I used a needle and applied a thin layer to both the top and the bottom of the wire. I then added another layer of film on top of the wires and trimmed the excess film from around the wires. Once I had the basic shape I covered the base in translucent clay, making sure the bases of all the wires were enclosed in clay.

I baked the tail in a pre-heated oven at   ̊275. At first I thought it would be a total fail because the film immediately shrunk a bit, but then it stabilized. My original goal was to see if I could bake it for 15 minutes. That came and went so I continued for a total of 30 minutes which was my ultimate goal. Why 30 minutes? Because the clay that I prefer bakes for 30 minutes per ¼ inch to cure properly. I knew I could attach a tail with ¼ inch or less thickness of clay so this was the perfect amount of time.

 

Here is what it looked like when I removed it from the oven after 30 minutes. Notice that the film is not super shiny and there is a gap at the top where the two separated.

  

Here it is once I heat the film with a heat tool and shaped it with a candle flame. Using the heat gun adhered the two layers of film together and made it shiny and translucent.

I consider this a success.

 

 

For my second try I went with a larger tail, one closer to what I will need for my mermaid.

I used the same steps, gluing the wires onto the film and adding a second layer of film on top of the wires. Shaping it and baking it for 15 minutes. This time the clay that I used on then end was only 1/8 in thick so I did not need the full 30 minutes.


Here it is direct from the over



Here it is once I heated it with a heat tool and shaped it with the candle flame.


 Here are both experiments. I’m very pleased. Yes, I know the tails look a bit ratty and have soot on them, I wasn't going for perfect, just making sure the film reacted the way I wanted it to.  

***Before baking your Angelina film test bake a sample to see how the color shifts***

My next step will be to design the tail for my current mermaid. Scary stuff. I am so happy with how she is turning out that I do not want to ruin her with a bad tail, but she needs a tail!



Here she is trying on one of the practice tails. 

She just came out of the oven and now has arms. Next up I'll be adding her hands, a tail and her hair. Stay tuned for more pictures

2 comments:

  1. Who would have thought, making a tail would be so scary and hard! LOL! Wishing you all the best! She is turning out beautiful!

    ReplyDelete
  2. Thank you :) I had fun working with the film and my experiment worked which makes me very happy!

    ReplyDelete